Linoleum is a practical and elegant coating that is often decorated with wooden houses, or rather, gender. One of the advantages of linoleum is that it can be laid without resorting to the help of professionals. Like the construction of wooden houses, it complies certain standards, and laying linoleum requires compliance with certain rules. To qualitatively lay linoleum in wooden houses, you need to clearly imagine what the result should be, as well as what improvised tools are needed.
The process of laying linoleum is divided into the following stages:
1. Preparatory stage. To lay linoleum in wooden houses nothing could interfere, the room must be completely released from furniture and other interior items. If there is already an old linoleum on the floor, then you do not need to rush to remove it. If it is relative to it, then the new one can be laid on top of the old. Thanks to this, wooden houses will retain the heat and softness of the floor. If there is a skirting board around the perimeter of the room, then it needs to be removed and replaced with a new. After the listed procedures, you need to make measurements of the room.
2. Direct purchase of linoleum. Wooden covers in wooden houses should be bought in specialized stores. Linoleum should be deployed, the pattern should be clearly shown. Be sure to consult with sellers. If they cannot give intelligible answers – go to another store. Building houses is a serious process that requires the advice of competent people.
After linoleum is bought, you need to purchase a plinth. The best – plastic skirting boards with a cable channel.
3. Lining linoleum. The material is rolled over the area of the room and all unnecessary. In general, so that everything goes smoothly, let Linoleum “lay down” at least two days. This will allow him to deal. It is recommended to leave 1-1.5 cm between the edges of the material and the wall, since after the linoleum straightens, the gap may disappear.
If a linoleum is a whole piece, then you can immediately install a plinth. But it often happens that separate pieces of material are selected in wooden houses. In this case, you should fasten these pieces with each other, or glue them with edges directly to the floor.
When everything is ready, lay out the baseboard, remove the excess and fasten them into the screws. Great coating in wooden houses is ready!
