Ceramic tiles simplify the maintenance of the furnace, improves its aesthetic appearance and increases heat capacity. If you follow the rules of the cladding, then ceramic tiles will last a long time and will not require annual cosmetic repairs (sealing cracks, whitewashing, etc. D.). If the construction of baths from a beam occurs, then here you can take into account the colors of the tiles, sizes for the interior, so that they are combined.
2 – clear and deepen the seams between bricks to one centimeter with a spatula;
3 – with a metal brush, clean the surface of bricks and seams from dust;
.
5-on the prepared surface of the furnace, a special grid with small cells is fixed, the dimensions of the latter are 50×50, with a diameter of 0.5-1.0 mm. You can attach the grid to the wall of the furnace with metal anchors or self -tapping screws. When using self -tapping screws, the holes are drilled with a winning drill, where they are screwed. . Pieces of wire are placed in the seams after 15-20 centimeters;
6 – having finished preparatory work, begin to prepare an adhesive solution. Use ordinary or heat -resistant tile glue that withstands the temperature to the degrees of Scanmix “Scanfixsuper”. It is produced in the form of a dry mixture, in which table salt is added at the rate of one kg of salt per bucket of dry glue. Salt will slow down the evaporation of water and improve the adhesive abilities of the solution;
7 – heat the oven to the maximum temperature and maintain it for the entire period of laying ceramic tiles;
8 – laying tiles begin from below. So that the seams between the tiles are the same use crosses. During the masonry, they constantly check its vertical. If the laying of the tiles is not adjusted immediately, then after drying this operation is almost impossible.
During the construction of baths from a beam, all materials are taken into account in the project and ceramic tiles are selected here based on the dimensions of the house, the type of furnace and design.
