Using the used floor decoration materials for flooring, implies compliance with both scientific and technical claims and claims of the ratio of finishing and building material. With flooring, the parquet in advanced criteria will need to take into account the variety of implementation materials. Everyone who was used owns a close purpose and in coordination with claims asks for analysis of interaction in conjunction with other materials. Probably the name of the physical and chemical interaction, which applies to the operating conditions of the plane of the finishing layer. So gluing mixtures, and solutions suggest using it according to both conditions and the materials of the flooring. Because various glue has different properties.
The use of gluing raw materials, which was used, requires a preliminary cycle, which in its own priority involves the requirements of the fortress, purity and evenness of the base for an impeccable joint. Which was used and the next operation of the floor plane. So, after all, adhesion has its own requests, including the use of a primer solution from time to time, it is allowed to use the same glue if its PVA base is based. Dispersive glue on the basis of PVA under the floor of a mosaic parquet, plugs and piece parquet is often used, this has special factors in accordance with the flooring technology. Since the hitch implies fundamental meaning in accordance with the parameters of compliance with technical factors, you will need to direct attention to subsequent points.
So on the basis for covering the floor, it will be necessary to make cleaning, which boils to the needs of cleansing such from pollution, dust and in individuality, pollution of maslenic occurrence require cleansing the introduction of primer. The primer layer is applied before using glue for parquet. The adhesive mixture is applied even by stirring the contents and therefore it will be necessary to use a gear spatula. The distribution of glue is made on the area comfortable for flooring parquet in such a way before it dries. The edges of the joints of the parquet that was used will also require lubrication with the support of the brush and, when the glue is at the junction. For the direction of the flooring and preserving the configuration, it will be necessary to use the marking of the plane of the strip in accordance with the edges to preserve the direction of the pattern.
After the parquet, the device is the need for the device of the so -called heat interval in accordance with the edges of the walls. This requirement takes place due to the reason that it will be necessary to take into account the fact that the constant movement of the walls on the expansion stems, so the value of such a seam is required to be 10-15 mm. The seam itself will become the next, covered with skirting boards.
