It is not difficult to install doors-wrappers. This only requires accuracy, as well as attentiveness and minimum number of standard tools.
Before installing doors-wrappers, you should make measurements of the doorway. After that, you need to purchase:
1. The door leaf, which should be five to seven centimeters higher and wider compared to the doorway. If you have a wide enough opening, experts recommend that you install double doors. In this case, take a few door leafs.
2. Furniture for sliding doors.
3. Door handles.
4. Square wooden beam with a cross -section of fifty millimeters. Note that the length of the beam is equal to the width of the door-wreck multiplied by two.
5. Fasteners (anchors, finish nails, wood screws).
The first step in the installation of a compolling door-it is necessary to fix the metal guide strips to the wooden beam using screws through the holes in the metal bar, which must be drilled in advance.
The next step – fix the bar to the upper end of the doors. In the future, this is useful when installing the upper guide rollers. In order to clearly put the door to an upright position, a special adjusting nut is used.
Then, in the lower end of the door panel, make a special groove chisel, which will serve for the movement of the lower guide roller. We draw your attention to the fact that the lower guide video is attached to the floor with self -tapping screws.
A beam with a fortified guide bar on it, using an anchor, is attached to the wall. In this case, it is necessary to achieve the horizontal arrangement of the beam, which excludes spontaneous opening or closing doors in the future.
It is necessary to insert the rollers into the guide bar on which the door leaf is attached.
To the floor, the guide of the lower video is attached using self -tapping screws. In this case, it is very important to arrange it strictly under the upper bar, otherwise the doors will not be installed vertically. After that, put the door leaf on the lower guide roller and install on the upper rollers. To avoid leaving the door outside the guide bar, you should use limiters of movement.
A wooden beam with a guide bar must be closed with a platband using finish nails. From the ends of the beam is covered with the same platband. After that, adjust the door leaf on the horizon and install the door handles, which often does not cause any difficulties.
