A heated towel rail is a convenient device with which operational dried of towels and fine linen is performed. Often, devices become unusable or there is a need to install another product, so you need to know how to replace the existing heated towel rail with a new. The process of dismantling the old product
Removing the old heated towel rail is quite simple, but it is best to dismantle it after or before the heating season, since there is a possibility. However, if there is a need for urgent replacement of a heated towel rail, then before work it is necessary to block the water on the entire riser in the room. After the riser is overlapped, it is necessary to completely drain the water from the system, and usually this process is carried out in the basement, where the tap necessary for draining the water is located. After that, the heated towel rail is simply dismantled from the installation site.
The process of replacing a heated towel rail
You can not only replace the product itself, but also the pipe of the riser. In some cases, this pipe is high-quality and durable, without any unnecessary clamps or peeling paint, so it does not change. The heated towel rail is removed from the pipe is very simple, because for this it is enough to unscrew its nuts and just remove it. If there is a need to replace the riser, then it is best to arrange all the joints formed directly above the floor so that they are invisible. You should not change the metal pipe to a plastic product, since this will not be created as a not too high -quality and reliable system.
Installation of a new heated towel rail
The new product is best fixed with the help of new and reliable fasteners, since the old ones are most likely not in the best condition. In most online stores, for example, in SantX. , and in ordinary stores, heated towel rails are already sold by sets. To fix the heated towel rail to the wall, you need to use a punch, with which the fasteners of the product are firmly attached to the surface. After creating the holes of the desired diameter, it is necessary to blow them and drive them to the dowel, after which it begins to screw the fasteners themselves. All holes should be at the same level, so that the heated towel rail hangs smoothly and beautifully.
At the end of the pipe to which the heated towel rail will be fixed, there should be a suitable thread that has the desired diameter. Typically, such a thread on metal pipes is performed independently using special tools, such as a dick. All nuts that are wound on the thread should be tightened very well. .
